Collapse bottom bar
Subscribe

Guns & Ammo Network


Ammo

.30 Remington AR

by Layne Simpson   |  January 4th, 2011 18

A .30 caliber cartridge designed specifically for the AR-15 platform.


Remington’s new .30 AR cartridge is the same length as the .223 and functions through the company’s standard R15, its version of the AR-15.

When Remington got into the AR-15 business in 2007, company officials made it clear that the new R-15 rifle was intended for hunting. At the time, that struck me as rather odd since the only chamberings offered were .204 Ruger and .223 Remington, both excellent varmint cartridges but a bit short on power for use on deer and such.

And since Remington had previously been involved in the development of an AR-15-compatible cartridge of larger caliber called the 6.8mm SPC, which is better suited for use on deer, I wondered why that chambering option was not offered. Little did I know at the time that an even more effective cartridge called the .30 Remington AR was on the drawing board.

When designing the new cartridge, Remington’s engineers started with the .450 Bushmaster case. For the benefit of those who are not familiar with the .450, it was a joint-venture development between Hornady and Bushmaster.

A pointed .30 caliber bullet of reasonable weight is longer than a blunt-nosed .45 caliber bullet, so to keep overall cartridge length compatible with the standard AR-15 magazine, the case was shortened to 1.530 inches from the original case length of 1.700 inches.

At its base, the .30 AR case has a diameter of .500 inch. From there it tapers forward to .488 inch at the juncture of the body and shoulder. Neck diameter is .342 inch, and the case has a shoulder angle of 25 degrees. With a length of .305 inch, the neck is capable of exerting plenty of tension on the bullet, a good thing to have in a cartridge designed to survive the rather violent trip it must take from the magazine to the chamber of an autoloading rifle.

An AR-15 rifle in .450 Bushmaster utilizes a standard .223 bolt, which is modified by increasing its bolt face diameter to a nominal .473 inch, which is the same as the .308 Winchester.

When this is done, the counterbore wall or shroud of the bolt becomes rather thin. This is considered a safe modification for that cartridge because it operates at a maximum chamber pressure level of 38,000 psi, which is the same as the .30-30 Winchester. But since the .30 AR is loaded to 55,000 psi (a bit higher than the .308 Winchester), Remington opted for additional case rim support. Engineers accomplished this by modifying the larger-diameter AR-10 bolt to fit the AR-15 upper.

The face of said bolt is commonly sized for the .473-inch rim diameter of the .308 Winchester, but Remington went one step further by opening it up a bit and increasing the rim diameter of the .30 AR case to .492 inch.

This, by the way, is a rather uncommon rim diameter. The only other cartridge I could dig up that shares it is an 1800s number called the .35-40 Maynard. At any rate, by the time the job was done, the only thing the .30 AR case had in common with the .450 Bushmaster case was a base diameter of .500 inch.

In case you are wondering why Remington went with a case rim diameter larger than that of the .450 Bushmaster, it is to prevent the use of a bolt built for that cartridge in an R-15 upper with a .30 AR barrel.

What we ended up with is a short, fat case of rebated rim design with a gross water capacity of 44 grains, about 10 grains less than the .308 Winchester case and approximately the same as the .30-30 Winchester case. But since the .30 AR is loaded to higher chamber pressures than the .30-30, it exceeds the maximum velocity of that cartridge.

For now, Remington is loading it with two bullets at 2,800 fps: 123-grain FMJ for practice and target shooting and 125-grain pointed Core-Lokt for hunting. The FMJ option is a member of the UMC family of economy-priced ammunition and is loaded with the same bullet loaded by Remington in the 7.62x39mm Russian. As for the other load, as Remington ads have told us for many decades, the Core-Lokt is the deadliest mushroom in the woods.

When either load is zeroed three inches high at 100 yards, it will strike about two inches above point of aim at 200 yards and approximately seven inches low at 300, where it is still packing upwards of 1,000 ft.-lbs. of energy.

Whether or not the .30 AR will eventually be offered in additional loadings remains to be seen, but in my opinion a bullet weighing 150 grains might just prove to be a useful option. My guess is it could be pushed along at 2,400 to 2,500 fps, placing the new cartridge in about the same performance class as the .300 Savage.

As I gaze into my crystal ball I also see the possibility of other calibers on the same case with .338, 7mm, .270 and .224 of interest to me. And while the .30 AR was designed with hunting in mind, it might be fun to see how it performs at medium-range paper-punching when handloaded with the Sierra 155-grain MatchKing bullet.

By now you might be asking yourself, why bother? Remington already has the R-25, and why buy a rifle chambered for a .300 Savage-equivalent cartridge when the R-25 is available in .243 Winchester, 7mm-08 Remington and .308 Winchester?

I can think of three reasons worthy of consideration. For one, the versatility of the R-15 is easily increased by switching out its upper for one in .204 Ruger, .223 Remington or .450 Bushmaster, an option that’s not possible with the R-25. For two and three, the R-15 is lighter and less expensive than the R-25.

Load Comments ( )
back to top