Model 1879 Trapdoor Springfield Carbine

Model 1879 Trapdoor Springfield Carbine

Despite detractors' comments, this handy little single-shot rifle was one of the best arms of its era.

By the time the Civil War ended, there was no doubt that the self-contained metallic cartridge was the wave of the future. With the successful, widespread use of the Spencer repeater as well as more limited employment of other arms such as the Henry and Joslyn, the message was clear: The percussion muzzleloader and breechloader were doomed.

Other countries were also in the process of switching over, and the United States didn't want to be left behind. With hundreds of thousands of rifle-muskets on hand, the obvious money-saving solution was to try to find some way to convert these arms to handle the more modern ignition system.


While some excellent newly made arms were submitted for testing, the prudent thing to do was to adopt a method that would be able to make use of the resources at hand.



The Yankees were not alone in this, and nations such as Britain, with its Snider conversion, and France, which adopted some muzzleloading muskets and carbines to the Tabatier system and Chassepot bolt-actions to handle the 11mm Gras cartridge, were also going in the same direction.

Uncle Sam tried many different arrangements before settling on one devised by Springfield Armory's master armorer, Erskine S. Allin. As well as being a slick setup, Allin was a government employee, which meant the war department would not have to pay royalties on the design.


Basically the system involved a breechblock that was attached to the top of the altered rifle-musket barrel. To open it, one half-cocked the hammer and pushed upward on a thumb latch to unlock the block. It would then be rotated forward to expose the chamber for the insertion of a round.


The block was then closed, the hammer put on full-clock, and the rifle aimed and fired. Upon reopening the block, a rather complicated rack-and-pinion extractor ejected the spent case. Fast, slick and easy.

As well as being relatively efficient, the conversion allowed the maximum use of original parts. Allin explained: "It is particularly adapted to the alteration of the Springfield rifle-musket, (or any other) as it can be done without changing the features of the musket or without throwing away any of its parts. All that is necessary is to cut away the barrel on the top at the breech and add the block and shell extractor, cut the recess in the breech-screw, and modify the hammer. All other parts remain the same."

The Trapdoor's

top-opening breechblock allowed the upgrade from black powder to smokeless while still retaining as many original parts as possible.

These were honeyed words to penurious ordnance officials. The system was adopted in 1865, chambering a .58 caliber copper rimfire cartridge that approximated the ballistics of the original muzzle-loader's paper cartridge. Because of this, even the rear sight didn't have to be changed.

Nicknamed the "needle gun" due to its long firing pin, some 5,000 of these Model 1865s were altered at Springfield before it was decided that some alterations in the mechanism and a reduction in caliber was warranted to further improve the gun's performance.

The original muzzleloading barrels were sleeved with a liner of .50 caliber to handle a new centerfire cartridge with a 450-grain lead bullet backed by 70 grains of black powder. This loading upped the velocity by 100 fps (1,260 fps) over that of the .58 rimfire and gave greater range and accuracy, though the muzzle energy was about the same (1,488 ft.-lbs.).

Because of complaints about cartridge cases becoming stuck in chambers, a trap was added to the butt that included a "headless case extractor."

A lighter carbine load featuring a 400-grain bullet and 45 to 50 grains of black powder was also issued and, as might be expected, the velocity and muzzle energy were somewhat reduced. Too, the old rack-and pinion extractor was found to be lacking, and a new ejector, which involved a small spring-loaded stud set in the breech just behind the chamber, was adopted. The block itself was also slightly modified by employing coil springs for both the firing pin and latch.

Dubbed the Model 1866, 25,000 of these rifles were turned out at Springfield using Model 1863 rifle-muskets as platforms. In 1867, a shorter Cadet Rifle appeared but still no cavalry carbines — that role being handled by the thousands of Spencer repeaters still in the system and Sharps percussion carbines converted to .50-70.

Even though the 1866 was considered a successful arm, some modifications were deemed to be in order. The extractor still left something to be desired, and a new version was designed that involved a spring-loaded claw set into the receiver at the hinge of the breechblock. Too, it was decided to shorten the gun's barrel and to adopt an en-block receiver that could be screwed onto the rear of the barrel. Other mods involved a new long-range rear sight and larger cam latch.

In 1870, the first carbine version of the Allin conversion appeared. It too used bits and pieces of Civil War muskets, but the barrel was shortened to 22 inches, the half stock fitted with only a single barrel band, and a bar and ring attached to the left side of the stock opposite the lock to enable the use of a carbine sling. Only 341 of these guns were made, making them among the rarest and most desirable of U.S. martial arms today.

Even during the heyday of the .50-70, it was recognized that .45 caliber was ballistically a better choice. Most Europeans were adopting "smallbore" .45 or 11mm loads, and it was finally decided that Uncle Sam should follow suit.

In 1873, a new model of Trapdoor (so-named because of the appearance of the breechblock) was introduced. Unlike its predecessors, it was not made from altered muskets but was fabricated completely from new. Also unlike the earlier guns, it was not finished bright but had blued metal parts with a case-hardened tang and breech and black oil-quenched breechblock.

The carbine rear sight was graduated to 1,300 yards — 100 yards more than the rifle. The carbine wasn't more accurate, of course — the sight radius just allowed more graduations.

Many of the parts were the same as those of the 1870 models, so Springfield was able to use some of the tooling for components on the older guns. The gun was offered in rifle, cadet rifle and carbine versions.

The .45 caliber cartridge, for which the guns were chambered, employed the Benet internal priming system and a drawn case with heavy copper content. Bullet weight was 405 grains, and the powder charge was 70 grains for the rifle (muzzle velocity 1,350 fps; muzzle energy 1,590 ft.-lbs.) and 55 grains for the more diminutive carbine.

In 1882, a 500-grain bullet was adopted for the infantry rifle. At the same time, the Benet priming was replaced with the Boxer external style.

The carbine itself was a very handy, attractive weapon. With its 22-inch barrel it resembled the 1870 in many details but incorporated a stacking swivel on the front band. The rear sight was graduated from 400 to 1,300 yards.

Though several modifications were made in 1879, the Springfield Trapdoor carbine was still considered a Model 1873 and is so marked.

Interestingly enough, the rifle's sights were graduated only to 1,200 yards, giving rise to the legend that the carbine was more accurate than the rifle. The simple fact is, because of the carbine's shorter barrel, the sight radius is different, making the graduations on the leaf closer together. Thus, it's possible to squeeze another 100-yard step onto the carbine sight.

Though delivery of the 1873s was slow, by the mid 1870s most of the regulars had been issued with them. Generally speaking, the soldiers liked their new arms and despite limited opportunities for target practice (marksmanship training didn't really become a priority until the 1880s) they became quite proficient with them.

The men of Lt. Col. George A. Custer's famed 7th Cavalry were carrying Model 1873 carbines at the Battle of the Little Big Horn in 1876. After the battle, it was claimed that many of the soldiers' carbines jammed because the sharp extractor finger was tearing away the heads of the soft cartridge case base, necessitating the men to try to pry the stuck shells out with their knives.

Recent forensics have shown that this did take place in some circumstances, but the extent to which it affected the battle is conjectural. There is good reason to believe that the carbine was actually used as something of a scapegoat to deflect attention from Custer's faulty handling of the battle and the defeat of modern troops by the Indians.

In 1877, the Trapdoors again underwent some alterations. The carbine butts were fitted with traps that held a jointed cleaning rod and broken shell extractor. The older "low arch" breech was replaced with a breechblock with a more curved inner configuration, and modifications such as the elimination of the firing pin spring, and other configurational alterations were made.

Even though the guns were different from their parents, they were still marked "Model 1873." It might be noted that many Model 73s had very deep stampings which made the "3" look like an "8," leading some collectors to think there actually was a Model 1878 Trapdoor. Such is not the case.

In 1879, the guns were again given a makeover. The carbine stacking swivel was eliminated, the receiver made thicker, and depending upon when the gun was made (180,000 were turned out between 1879 and 1885) they were fitted with ribbed triggers. Though considerably different from the earlier versions, these were still considered Model 1873s by the government and are so marked.

The Trapdoor rifles, carbines and other variants continued to be issued and carried right up to the turn of the century, and modifications such as different sights, ramrod bayonets, etc. popped up from time to time.

The Trapdoor's last moment of glory was during the Spanish American War when, in the hands of volunteers, it fought side by side with the modern smokeless powder Krag-Jorgensen repeating bolt action.

I have several Trapdoors in my collection, both rifles and carbines, and have fired them for years, using proper modern smokeless loads and replicated period black powder cartridges. Even though it had been perfected, the Allin action is still not the strongest single-shot ever made, and if you have an original Trapdoor, first take it to a qualified gunsmith for a going over and then never fire the gun with loads exceeding original chamber pressures of around 25,000 psi.

That being said, I have found the Trapdoor to be one of the most reliable and accurate military rifles of its type. In shooting comparisons with the French Gras, British Martini-Henry, German 1871 Mauser, Austrian Werndl and Model 1870 Remington Rolling Block, of the batch only the rolling block is as accurate and the Martini-Henry as fast to load.

While naturally the rifles are more accurate than the carbines, for sheer shooting fun, I'll take my 1879 carbine over the lot of them. It's handy, light, responsive and as accurate as it has to be for the uses for which it was originally intended. The buckhorn rear sight is not as technologically advanced as the later multi-adjustable Buffington, but it allows for rapid target acquisition and is simple and easy to use. To my mind the 1879 is the ne plus ultra of the Trapdoor carbines.

Recommended for You

If you're a serious shooter with deep pockets, these Leica products are worthy of consideration. Accessories

Three Rangefinder Products from Leica

J. Scott Rupp - May 08, 2019

If you're a serious shooter with deep pockets, these Leica products are worthy of...

The author takes stock of rimfire rifles he's known and loved. Ammo

.22 Memory Lane

J. Scott Rupp - January 04, 2019

The author takes stock of rimfire rifles he's known and loved.

Announced in 1958, the .264 and .338 Winchester magnums hit the market in 1959 amid one of the biggest media blitzes the industry had seen. Both were introduced in “new” versions of Winchester's beloved Model 70. Ammo

.264 and .338 Magnum - Winchester Twins

Craig Boddington - May 24, 2019

Announced in 1958, the .264 and .338 Winchester magnums hit the market in 1959 amid one of the...

See More Recommendations

Popular Videos

Springfield Armory Saint Victor

Springfield Armory Saint Victor

The SAINT' Victor Rifle delivers a lightweight and agile rifle solution while maintaining effectiveness at extended engagement distances.

Steyr Arms Announces Sniper Rifle in 6.5mm Creedmoor

Steyr Arms Announces Sniper Rifle in 6.5mm Creedmoor

Scott O'Brien from Steyr Arms sat down with Michael Bane at SHOT Show 2018 to take a look at Steyr's new tactical heavy barrel sniper rifle in 6.5mm Creedmoor.

Black Hills Evolution of Rifle Cartridge: .308 Win. 175 Gr. Match

Black Hills Evolution of Rifle Cartridge: .308 Win. 175 Gr. Match

David Fortier talks with Jeff Hoffman of Black Hills Ammunition about the evolution of the .308 Win. 175 Gr. Match bullet.

See more Popular Videos

Trending Stories

Gunsite's Ed Head reviews the Ruger American/Robar Scout Rifle. Bolt-Action

Review: Ruger American/Robar Scout Rifle

Ed Head - April 23, 2019

Gunsite's Ed Head reviews the Ruger American/Robar Scout Rifle.

On June 2, 2014, Anschutz announced the start of a subsidiary branch in the United States. Industry

Anschutz Establishes U.S. Branch, Separates from Steyr

RifleShooter Online Staff - June 10, 2014

On June 2, 2014, Anschutz announced the start of a subsidiary branch in the United States.

Some history and reloading recipes on five popular .17-caliber cartridges, including the .17 Ackley Hornet, .17 Hornady Hornet, .17 Mach IV, .17 Remington Fireball and .17 Remington. Reloading

.17-Caliber Reloading Data and History for 5 Cartridges

Layne Simpson - June 05, 2019

Some history and reloading recipes on five popular .17-caliber cartridges, including the .17...

See More Stories

GET THE MAGAZINE Subscribe & Save

Temporary Price Reduction.

SUBSCRIBE NOW

Give a Gift   |   Subscriber Services

PREVIEW THIS MONTH'S ISSUE

GET THE NEWSLETTER Join the List and Never Miss a Thing.

×